MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Dual Powered Willem Programmer
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Robert Kenney

USA
2 Posts

Posted - 03/13/2005 :  14:53:39  Show Profile  Reply with Quote
I am new to this programmer, and have a few used D8751 MCU's. I would
like to program these (4K onboard) but do not see them listed
with any adapters. Can I use the AT 89 adapter?
Reply #1

usb

138 Posts

Posted - 03/15/2005 :  12:23:22  Show Profile  Reply with Quote
The AT89 adapter is supportingD8751 and D87C51. The 87C51 should not have any problem. However for D8751, since it is not a CMOS chip, it will need much higher DC current for programming. You may need do some small modification on the programmer to increase the DC current when you reading/programming the D8751. Just replace the VCC control transistor to a higher current transistor, and use a DC power supply intead of the USB power cable. The on board VCC control transistor only be able to provide up to 200mA current. You may need a 500mA transistor.

Edited by - usb on 03/15/2005 12:26:40
Go to Top of Page
Reply #2

Robert Kenney

USA
2 Posts

Posted - 03/16/2005 :  16:51:14  Show Profile  Reply with Quote
Thanks for the reply. The documentation was somewhat confusing. As for
the chip, I misread it (the problem with old faded chips), it is a
D87C51 so I should not have to modify anything.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000