MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Cant program 2732's....HELP
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

luvmy64

1 Posts

Posted - 06/06/2005 :  16:01:49  Show Profile  Reply with Quote
I have the dual power programmer and i cant get it to program my 2732 chips. It says chip read ok, verify ok, and device empty, but i get an error message when i try to program it. it says ERROR at 0x000000 CHIP= 0xFF Buffer=0x4A
Ive notice that 4a is the first set of numbers in my hex, and ive also noticed that the checksum isnt right when i load the bin into the program. How do i change the vpp? could this have something to do with it? I cant find the jumper settings anywhere on this site. HELP
Reply #1

usb

138 Posts

Posted - 06/07/2005 :  13:30:58  Show Profile  Reply with Quote
The 2732 needs 25V Vpp setting. Change the Vpp by set the JP5 and JP6.

The checksum in software is a simple-add-on checksum. As long as every time load the data you can get same checksum, then that is OK.

Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.12 sec. Snitz Forums 2000