ZLM |
Posted - 08/24/2008 : 10:20:27 There are no special setting on the comport from the Windows control pannel. That because the software does not use windows driver and will directly talk to the comport. So, the important stteing is in the JDM software. Please see attached puicture.
Also, -Please make sure the comport number is correct set in the software -Make sure the cable you used is correct. If you are not sure, try to directly connect the programmer to the comport with out cable by removing two screws on the connecter.
Software example: WinPIC800:
49.48 KB |