MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 29LV160

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
kuurgen Posted - 04/02/2007 : 19:54:22
Well, I've spent a good 3 hours trying to erase a at29lv160 chip.
I can read the chip, but I'm not sure I'm reading correct data.

When I do a get id i get a 0x18

What am I doing wrong? I have a tsop48 adaptor, when I try to erase
the chip I get a cannot erase chip.

The manual shows a TSOP 48 adaptor that I don't have. (slightly diff config)

The manual shows a jumper jp1 as a 3.3 when open. So I remove the jumper cap and thus it's open for 3.3?

Sorry the manual for this thing is less than clear.

I was able to reporgram a computer bios chip no problems, however I
don't think this think is reading correctly and is definately not erasing or writing.

There is also a JP3 on the tsop 48 that I have no clue as to what it's function is.

I also have select VCC 3.3~3.6 pop up on the screen when I run certain
versions of the software.
What does this mean? I'm following the damn dip switch prompts.
I know you didn't write this software, but a "Please select 3.3 voltage somehow somewhere=) would be nice instead of a cryptic
message with a ~ placed in it.

(yes I'm frustrated, it shows doesn't it?)


I've tried opening jumper j1 on the mismatched tsop48 adaptor, but as it's NOT the exact same adaptor, I don't know what it's doing.

I understand that writing chips is a complex business, but the manuals seem to be in a poorly translated english.

I would like to know:

Do i need a seperate power adaptor to program this chip?
Do I need to change any specific jumpers?
My address lines match up.

I keep reading about how, i need 12.5 to bypass the security section of this chip, but from what i read it should be doing that if the jumpers are set to 12.5.

Please, be gentle I'm new, I know I sound peckish, I want this thing to work.




MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000