T O P I C R E V I E W |
cpsteve |
Posted - 06/15/2007 : 21:59:03 hi!
i'm trying to program some type of eproms, mainly 27c160
it's all ok, program works and say OK when finish to burn, but when it start the VERIFY give me this error message:
000001:Error at (file=e3,device=ff)
i replace the eproms on my top2048 programmer and test it and it's blank, not programmed.
someone can help me?
thanks in advance.
Steve |
1 L A T E S T R E P L I E S (Newest First) |
ZLM |
Posted - 06/24/2007 : 00:08:18 Check the Vpp pin if it is correct during the programming. If the Vpp correct (about 12V), then the programmer need to repair. |
|
|