MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X, GQ-3X, GQ-4X)
 Write ST95160

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
Perryking Posted - 12/17/2015 : 03:17:43
Hi, I have the new GQ4X and I can read ST95160 but not write. It fails and say Device not supported. So GQ4X can't write ST95160?
6   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 12/21/2015 : 12:05:35
The in-circuit programming need to power the board separately. The programmer only connect the GROUND and other signals.

anniel Posted - 12/17/2015 : 07:45:37
Bad contact to pins is always a possibility
Perryking Posted - 12/17/2015 : 07:41:58
I changed Pomona clip for a new 3M clip and it worked. Thanks.
anniel Posted - 12/17/2015 : 04:31:21
Pin 3 is grounded?
Perryking Posted - 12/17/2015 : 03:50:43
Yes, in circuit. But I read/write this eeprom in other boar in circuit without problems. What can I do?

Verify Failed. Address=0x000000, Device=0x01, Buffer=0x00
anniel Posted - 12/17/2015 : 03:36:56
Is it in-circuit?

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000