T O P I C R E V I E W |
drummerdude |
Posted - 06/23/2007 : 11:45:51 whenevr I try to program my chip I get ERROR:WRITE SECTOR ZERO |
7 L A T E S T R E P L I E S (Newest First) |
ZLM |
Posted - 07/07/2007 : 12:34:35 can you give a picture of your programmer with chip on it? so that I can take a close look. |
drummerdude |
Posted - 07/06/2007 : 20:07:00 when I try to verify it shows, error at 0X000000..... |
ZLM |
Posted - 06/25/2007 : 19:43:08 If the software verified OK, then it should be programmed correctly. Otherwise the verification will fail. |
drummerdude |
Posted - 06/25/2007 : 16:26:40 I had to change computers, but now when I burn the chip, and then read it, it is not what I burned on there. |
ZLM |
Posted - 06/25/2007 : 08:19:54 See: http://www.mcumall.com/forum/topic.asp?TOPIC_ID=97 |
drummerdude |
Posted - 06/24/2007 : 10:10:46 what should they be set at, all the jumper that are shown in the softwar window (when AT29C256 is chosen) I have them set to that, but it doesn't show all the jumpers? |
ZLM |
Posted - 06/24/2007 : 00:03:20 Check jumper settings. |