MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X, GQ-3X, GQ-4X)
 erase and record AT49F040-12TI

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
andres Posted - 12/15/2007 : 10:39:43
Hello I have just received the programmer GQ-3X Re-1.00 with adapter for the memory AT49F040-12TI, I can read the information of the memory but he/she doesn't allow to fade it write it again. you could you explain to me that I should make. thank you
2   L A T E S T    R E P L I E S    (Newest First)
Fabian_12345 Posted - 10/22/2015 : 05:52:47
[quote]Originally posted by andres

Hello I have just received the programmer GQ-3X Re-1.00 with adapter for the memory AT49F040-12TI,

That memory adapter is received and select in the soft programmer.
PD is a little older this topic but I am now emerged the probloema
Thank you,
ZLM Posted - 12/15/2007 : 15:39:46
The chip need to be erased/blank check before write the new data.
The correct steps:

1.Connect the programmer and run the software.
2.Select device from the device list: eg: AT49F020
3.Place the chip in the ZIF. If the chip is not in DIP package, then the adapter is needed.
4.Click on the ID, the chip should be detected correctly. If not, confirm the chip is on correct position in ZIF and well contacted with the ZIF. Also, you may need to clean up the pins if needed.
5.Read the chip twice and checksum should be same.
6.Save the buffer as a file for backup the original data if needed.
7.Change/load the data as needed
8.Erase the chip
9.Do a blank check and the chip should be blank.
10. Click the Write button to write the chip.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000