MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 FUSE settings for pic18F2450

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
aERonAUtical96 Posted - 12/01/2008 : 22:31:29
Having problems w/ the PRG-017 programming the FUSE config bits on the PIC18F2450 chip. I attempt to program a HEX file w/ appropriate FUSE values. The hex appears to be set, but the FUSE settings will not. What setting am I missing?
2   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 12/03/2008 : 11:58:45
Does the software load the configuration bit correctly from the hex file?
Try to increase the delay time in ".cid" file.
aERonAUtical96 Posted - 12/02/2008 : 07:11:09
Why will the software not erase the FUSE configuration? It won't set the config bit values from the HEX file

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000