MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 General Discuss
 Can read but not write with dual programmer

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
joncom Posted - 11/12/2004 : 07:38:41
I try to burn a 2732A chip. I can read similar chips, I can verify that the new is blank, but I can't write to the chip. It says programming chip(the red status bar increases), but the chip is still blank. I have a 12 V power supply and have set all the jumpers according to the software(I think). I have tried another PC, but same problem. Any Ideas?
THanks

JOn
1   L A T E S T    R E P L I E S    (Newest First)
usb Posted - 11/13/2004 : 23:22:23
Most likely your Vpp setting is not correct.
Also, the Vcc you need set to 6.2V.

Most of 2732 uses 25V Vpp, but some may use 21V or 12V. Confirm your chips Vpp from the datasheet.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000