MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 SST27SF512 not erasing

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
dkedrowitsch Posted - 10/19/2006 : 15:01:40
I'm using version 1.06 of the software.

I have set the dip switches according to the picture in the software after selecting the proper device.

Reading and programming the SST27SF512 seems OK, but when I click erase and confirm it quickly returns the message "The device has been erased". However upon verification all the data is still intact.

Could someone please look into this and let me know what I should do?

The whole reason I purchased this programmer was to program and erase these exact chips. Without this ability the programmer has no use to me.

Thanks!
Dieter
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 10/20/2006 : 10:48:59
The SST27SF512 is supported by this programmer.

Please check all pins on the chip are clean and has no contact issue.
As well as the chip is a good chip.
Let me know if this does not work.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000