MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Automobile engine ECU, Immo, Air bag chip tunning
 How to read copy protected M27c256b?

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
passuff Posted - 11/11/2010 : 12:53:31
Hello!

I have a 27C256B with a copy protection socket. From what I read in other forums, this eeprom can be read - but its not so easy. If ECU is reading a single adress from EEPROM it switches CS (chipselect) every time. If I want to read with programmer, chipselect is always set tpo on... This is noticed by the little extra IC on the socket and it returns only crap data...
So I need to write a skript for my willem Programmer to switch CS after reading an adress... But I dont know how... someone does?
2   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 11/14/2010 : 10:14:49
no. That pin is controlled by software automatically.
passuff Posted - 11/11/2010 : 14:39:22
maybe i was wrong... its not CS its OE output enable.
Is there a way to toggle OE after reading a single address?

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000