MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 M27C256B File Offset problem

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
erps Posted - 05/08/2015 : 05:26:15
I have loaded an HEX file with the corresponding File Offset 8000.
However, when I check what is in the buffer by clicking on the Code tab, I see addresses from 0000 to 7FF0 filled with FF, but can't scroll down to see from 8000 to FFFF, where the code is supposedly to be.

So when I program the chip, it doesn't do anything because the chip is being programmed with FFs. What I am doing wrong?

Thanks,
4   L A T E S T    R E P L I E S    (Newest First)
erps Posted - 05/19/2015 : 08:56:39
quote:
Originally posted by ZLM

If you set the file offset in software, then the software load the data starting from 8000. If the data beyond that location, then software will ignore it.

If your file has build in offset 7FFF, then you need to put file offset value to -7FFF, in that case, the software load the data from 000.



It worked by entering the File Offset -8000
Thanks for the tip.
ZLM Posted - 05/14/2015 : 17:58:59
If you set the file offset in software, then the software load the data starting from 8000. If the data beyond that location, then software will ignore it.

If your file has build in offset 7FFF, then you need to put file offset value to -7FFF, in that case, the software load the data from 000.
erps Posted - 05/13/2015 : 16:24:56
quote:
Originally posted by ZLM

The chip only has maximum address up to 7FFF. So, no way to see beyond the that point.



Ok, so what I need to do to see the code between 0000 and 7FFF?
ZLM Posted - 05/13/2015 : 15:31:50
The chip only has maximum address up to 7FFF. So, no way to see beyond the that point.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000