MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 JDM Enhanced + 16F688

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
bulldog_99_00 Posted - 05/29/2008 : 17:50:03
Hello,

I just received my JDM Enhanced programmer.

Using WinPic800, the programmer is detected OK, and the chip is also detected OK. When I program, the red light flashes as it should.

I always get this error though:
"ERROR -> Verifying address 0x000000
Verified : 0x2805 Read : 0x2800"

I assume that means that the programming didn't even get past the first byte.

Any ideas?

Thanks


1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 06/04/2008 : 08:27:03
You code protection bit maybe enabled. Check the CFG word setting.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000