MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Unable to burn 27cxxx

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
gkoutsis Posted - 09/22/2005 : 05:30:03
I got the enhanced USB powered programmer.

I can read and verify all my eeproms (27c64,27c256 and 27c512) but by the time I try to write them (yes they are empty and all check out with the blank test) I get an error after the first bit. Sometimes they seem to program and fail at the last bit but the chips are still empty after the "programming".

yes, I've tried all the different setting in my BIOS and on 3 different PCs.

I am out of ideas here....
3   L A T E S T    R E P L I E S    (Newest First)
firyembers Posted - 10/19/2005 : 07:49:31
Hi
I purchased one of these (PRG 001) April 2005,and have been well pleased with it,it does burn 27xx series as per instructions provided with the kit.

1.Verify the eprom is empty,leaving it in the UV eraser a longer time(i found the erase times differ from even the same manufacture even brand new)if after one time if does not verify empty.
2.Remove the jumper above the ZIF socket and press once the button to the right of the jumper,this sets the voltage to 15v.The 27xx is 12v proram.
Now you are ready to program.
When finished,replace the jumper(You will see the 15v led go off and the left led go on(the jumper is a safety feature and resets the voltage so as to not damage flash eeprom's)
regards
G
usb Posted - 09/27/2005 : 14:39:00
Read and then Verify a chip does not means the programmer been working correctly. That because the software does not verify the hardware jumper/DIP setting before read/verify.

You still need check following points:

-Chip's location and orientation in ZIF.
-DIP switch setting.
-Blank check chip before doing write.
backbiter17 Posted - 09/23/2005 : 09:52:36
i think your (& my) programer does NOT support those chips
br, ales

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000