Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
SpartanXx666xX
Posted - 07/17/2010 : 21:27:16 okay i got the programmer working now.
but a few questions:
when i load my hex file and click on verify i still get an error saying good 0x2b04 bad 0x000
but when i click on program it programs the chip....should i be worried about that?
also once i click program and the software programs the chip it says program complete. and when i try to read the chip it opens with all 3FFFF almost like its blank
is that suppose to happen or is the hex file that i just programmed it with suppose to show up??
1 L A T E S T R E P L I E S (Newest First)
ZLM
Posted - 07/17/2010 : 22:27:01 Looks like the chip is code protected.
If chip been protected, the you are unable to read it or verify it afer it locked.