MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 error when programming AT29C256

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
drummerdude Posted - 06/23/2007 : 11:45:51
whenevr I try to program my chip I get ERROR:WRITE SECTOR ZERO
7   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 07/07/2007 : 12:34:35
can you give a picture of your programmer with chip on it? so that I can take a close look.
drummerdude Posted - 07/06/2007 : 20:07:00
when I try to verify it shows, error at 0X000000.....
ZLM Posted - 06/25/2007 : 19:43:08
If the software verified OK, then it should be programmed correctly. Otherwise the verification will fail.
drummerdude Posted - 06/25/2007 : 16:26:40
I had to change computers, but now when I burn the chip, and then read it, it is not what I burned on there.
ZLM Posted - 06/25/2007 : 08:19:54
See:
http://www.mcumall.com/forum/topic.asp?TOPIC_ID=97
drummerdude Posted - 06/24/2007 : 10:10:46
what should they be set at, all the jumper that are shown in the softwar window (when AT29C256 is chosen) I have them set to that, but it doesn't show all the jumpers?
ZLM Posted - 06/24/2007 : 00:03:20
Check jumper settings.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000