Note: You must be registered in order to post a reply. To register, click here. Registration is FREE!
T O P I C R E V I E W
Posted - 11/16/2015 : 02:46:48 Hi MCUmall,
I was using GQ-4X Re=1.40 (SW Re=3.36) on a W8.1 machine. Was good. I just updated to W10 and now the batch run button is no more working.
It looks like burning is running but in reality the chip is not burned at all. Even more verification tells everything is fine but it is not (I used to select 'Verify' in the batch tool). To get a "real" comparison, I have to open the code file again and launch a 'Verify' command. It then shows that the chip does not have the same code as the source file....
Looks like the "Auto" button is re-writing the same code as the one into the chip ????
No other way than to do the operations "manually" : clear/ check blank / Write / Verify.
Not sure if I need to update the software ?? any clue ?
2 L A T E S T R E P L I E S (Newest First)
Posted - 11/19/2015 : 00:57:59 Thanks ZLM
Downloded Re6.38 and its working again.
Posted - 11/18/2015 : 08:04:58 Update you software to latest version.