MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 device starting point
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

84sslt1

USA
13 Posts

Posted - 04/25/2008 :  03:38:14  Show Profile  Reply with Quote
Willem dual powered usb unit ,, sst flash chip, Will I be prompted to set this start point? And when? Tim
Reply #1

ZLM

2937 Posts

Posted - 04/25/2008 :  08:36:16  Show Profile  Reply with Quote
No prompt message. But there is an Offset(Hex) box to fill up.
Go to Top of Page
Reply #2

84sslt1

USA
13 Posts

Posted - 04/25/2008 :  09:28:17  Show Profile  Reply with Quote
What do I put there? Is that value specific to the chip type?
Go to Top of Page
Reply #3

ZLM

2937 Posts

Posted - 04/25/2008 :  16:22:25  Show Profile  Reply with Quote
It can be set on any flash chips. Such as 27SF512.
Go to Top of Page
Reply #4

84sslt1

USA
13 Posts

Posted - 04/29/2008 :  16:05:53  Show Profile  Reply with Quote
What value do I set it at?? Somewhere I saw set it to zero.. Is there a hex number specific,,, ??
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000