MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using the AVR JTAG ICE and AVRISP ISP programmer
 Upgrade the firmware of JTAG+AVRISP 2-in-1 V2
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ZLM

2937 Posts

Posted - 12/22/2008 :  18:19:59  Show Profile  Reply with Quote
PRG-036 AVR JTAG ICE and AVRISP 2in1 programmer V2




For the AVRISP and JTAG ICE programmer V2 firmare update, It only can update the JTAG firmware.

For the JTAG firmware update, please follow the following steps:

1. Connect the programmer V2 and check which comport is assigned to the V2. Only COM1 to COM4 will be checked. If your V2 comport is greater than COM4, then you have to change it.

2.From AVR Studio, select menu Tools->AVR Prog... then it will detect the programmer and show the upgade window. See picture.




3. Clik on Browse botton and locate the Hex file "Upgrade.ebn" from following location:

"C:\Program Files\Atmel\AVR Tools\JTAGICE"

4. Click on Flash Program, it should start to upgrade the firmware. Once program finished, it will start to verify and gives the verify error. That because the programmer has both AVRISP and JTAG firmware, not only the JTAG firmware. Ignore the error message.





5. Disconnect programmer and reconnect it again. It should be ready for use.
Reply #1

murks007

1 Posts

Posted - 07/23/2009 :  10:41:27  Show Profile  Reply with Quote
Hello,

I bought a 2in1 programmer a few months ago.
And I've to say, it's a good product.
But now I've a question.
Is is also possible to update the ISP Firmware?
So I can programm the new XMega- Series now?

Thank's a lot,
Michael

Go to Top of Page
Reply #2

ZLM

2937 Posts

Posted - 07/24/2009 :  07:28:52  Show Profile  Reply with Quote
No. Only JTAG can be upgraded. The JTAG still can be used as programmer too.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000