| Author |
 Topic  |
|
|
kmoonen
Canada
4 Posts |
 Posted - 01/13/2006 : 01:50:55
|
Ok i am trying to read a atmel at89c52, but it shows up empty.
any ideas using a Dual Power Willem Universal EPROM Programmer with a MCS-51/51AVR/AT89 w/PLCC44 adapter |
|
| Reply #1
ZLM
2947 Posts |
Posted - 01/13/2006 : 12:04:33
|
The reson should be one of followings:
1.The chip is a blank chip.
2.The chip's lock bits been set.
3.The jumper/DIP setting on the programmer are incorrect. You should be able to get correct ID if the jumper and the DIP setting are correct. |
 |
|
| Reply #2
kmoonen
Canada
4 Posts |
Posted - 01/13/2006 : 12:27:02
|
Can anyone post the correct dip settings, the chip is definately not blank, as it works, i need to make some copies..
Pictures would be helpful |
|
|
| Reply #3
kmoonen
Canada
4 Posts |
Posted - 01/13/2006 : 17:20:36
|
| If this chip is locked, how do I unlock it?? |
|
|
| Reply #4
ZLM
2947 Posts |
Posted - 01/16/2006 : 15:06:57
|
DIP setting: 2,3,5,6,8,10,12 ON and 1,4,7,9,11 OFF. Using default jumper setting. Try ID the chip. If you can get correct ID, then your setting should be OK.
There are no way to unlock it. Unless erase it, but the data in chip will be erased too.
But, always, there are people having their ways to unlock it. See http://www.break-ic.com |
Edited by - ZLM on 01/16/2006 15:12:22 |
|
|
| Reply #5
kmoonen
Canada
4 Posts |
Posted - 02/08/2006 : 10:54:43
|
I still cant get a chip ID can someone post the correct jumper settings.
Thank You |
|
|
| Reply #6
ic_001
3 Posts |
Posted - 06/25/2006 : 21:42:14
|
| if you want to read locked mcu data,you can connect with icdesigner@126.com |
|
|
| |
Topic |
|
Programming ATMEL AT89c52
Forum Locked
