MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 cannot program am29f040b
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

alsauto

5 Posts

Posted - 02/10/2006 :  11:17:51  Show Profile  Reply with Quote
This is my second post with this problem, how can i tell if my programmer is working correctly, this chip is supossed to be supported by this programer. (will this dual powered programer work on this chip) I am trying to program a AM29F040B chip but I keep getting an error at 0x0001a8 chip=0xe5. I can id the chip ok. When i erase this chip it goes to about 12% then says erase completed by check DQ7, when i do a blank test it tells me the chip is blank. one time it programed all the way but when i read the chip it is empty. I have tried 5 different chips 4 different computers, when i test hardware the vpp is getting 12vots, vcc is 5volts. the vcc led comes on when i erase and try to program, the red led does not light at all except for when i first turn the computer on then it goes out after I start EPROM3. the jumpers and dips are set as it shows in the software. I am chosing the M29F040B from the device menu as i do not see a choise for Am29F040B. the bios is set for ecp/epp have also tried ecp did not make a difference. any help would be appriecated. Thank You
Reply #1

ZLM

2920 Posts

Posted - 02/10/2006 :  22:32:19  Show Profile  Reply with Quote
Please confirm all the jumper settings. Also, in software should display "PCB3" on title bar.

Also, check all the IC on the programmer board, see if any ic got contacting problem with the IC. Do a switch for the same part IC see if any thing changes. Like CD4015.

Edited by - ZLM on 02/10/2006 22:36:05
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000