MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 Problem with my ICD 2.5
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Daperron

1 Posts

Posted - 10/22/2009 :  10:07:44  Show Profile  Reply with Quote
Hi,

Got a problem with my programmer.
I think that the installation is ok, but with MPLAB 8.4, when I connect the programmer to the PC, I got this message :

Connecting to MPLAB ICD 2
...Connected
Setting Vdd source to MPLAB ICD 2
ICDWarn0020: Invalid target device id (expected=0x44, read=0x0)
...Reading ICD Product ID
Running ICD Self Test
... Failed Self Test. See ICD2 Settings (Programmer->Settings) (status tab) for details.
MPLAB ICD 2 ready for next operation

In the setting table :

Target VDD : 0
Target VPP : 11.10
MPLAB ICD2 VPP : 11.26

I refresh and I have always 0V VDD... and Yes I check Power target circuit from MPlab....

Can you help me??
Reply #1

ZLM

2923 Posts

Posted - 10/24/2009 :  23:42:06  Show Profile  Reply with Quote
If you already did "check Power target circuit from MPlab", then you maybe burned out the VDD control transistor V512.

This may happen if you have shorted the VDD line to ground accidentally or placed a PIC chip(reversed).

In that case you need to repair the unit. Replacing the V512 transistor.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000