MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Dual Power Willem and PIC16F877A
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

infrared

Greece
3 Posts

Posted - 11/23/2009 :  14:20:13  Show Profile  Reply with Quote
Hello,

i have the Dual Power Willem Universal EPROM Programmer and
i want to program the PIC16F877A thru ICSP but with no luck.

When i click electronic Id button it displays ???? in Device Pic Name.
The problem is that when programming the PIC return "Error verifying PIC"

The pins of ICSP (J5) in my programmer is from bottom to up:
1. VPP
2. Vcc
3. GND
4. RB7
5. RB6

When i check the voltage from every pin i have
vpp = 12.5 volt
vcc = 5v
rb7 = about 0.7
rb6 = about 2.7

I use DC 9 volt power.

The software i use is 0.97ja.

What am i doing wrong ?
I programming 2716 and 2732 eproms with no problem at any voltage.

Please help!!!
Reply #1

ZLM

2937 Posts

Posted - 11/23/2009 :  16:39:22  Show Profile  Reply with Quote
Double check you connection again.
Go to Top of Page
Reply #2

infrared

Greece
3 Posts

Posted - 11/24/2009 :  00:40:57  Show Profile  Reply with Quote
You mean to check the ICSP pin connection or something else ?
Go to Top of Page
Reply #3

infrared

Greece
3 Posts

Posted - 11/26/2009 :  00:28:06  Show Profile  Reply with Quote
Any help about my problem please ?
Am i doing wrong something ?

Go to Top of Page
Reply #4

ZLM

2937 Posts

Posted - 12/01/2009 :  21:17:13  Show Profile  Reply with Quote
ICSP pin connection and DIP setting.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000