MCUmall EPROM BIOS Chip Burner Forum
Home
|
Profile
|
Register
|
Active Topics
|
Members
|
Search
|
FAQ
Username:
Password:
Save Password
Forgot your Password?
All Forums
MCUmall Forums
Automobile engine ECU, Immo, Air bag chip tunning
verify M93C56
New Topic
Reply to Topic
Printer Friendly
Author
Topic
ricampr
Portugal
21 Posts
Posted - 04/30/2010 : 12:49:47
Hello.
I have an eprom M93C56.
read ok
write ok
verify failed
which may be the problem?
thanks
Reply #1
ZLM
2941 Posts
Posted - 05/06/2010 : 16:21:45
What adapter you used?
Check pin contact.
Reply #2
brchip
Brazil
16 Posts
Posted - 06/26/2010 : 16:48:24
I'm having the same problem. I'm using 3M soic8 clip. I used this clip for other chips and it worked fine.
Please help.
Reply #3
brchip
Brazil
16 Posts
Posted - 06/26/2010 : 16:56:49
Same here. I'm usng 3M clip with sw v4.01. Should I upgrade to the latest sw?
I tried different speeds and devices (8 and 16 bits) but no luck.
Any ideas?
Reply #4
ZLM
2941 Posts
Posted - 06/26/2010 : 21:33:23
Are you doing it while the chip on the PCB?
Reply #5
brchip
Brazil
16 Posts
Posted - 06/27/2010 : 04:40:09
Tried both ways. Reads and writes but verifiy gives error.
I tried 8 bit and 16. Is there a way to know which is the correct?
Reply #6
ZLM
2941 Posts
Posted - 06/27/2010 : 06:32:34
I recommend you to remove the chip from PCB and put it in the adapter to read and write.
That way is the standard programming way.
Reply #7
brchip
Brazil
16 Posts
Posted - 06/27/2010 : 16:39:21
I already did, but it always gives an error in the verification.
Reply #8
ZLM
2941 Posts
Posted - 07/01/2010 : 09:50:01
use slower speed.
See:
www.youtube.com/watch?v=ibd910i48CE
Topic
New Topic
Reply to Topic
Printer Friendly
Jump To:
Select Forum
MCUmall Forums
General Discuss
Novice Place
True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
GQ-5X
Automobile engine ECU, Immo, Air bag chip tunning
Using The Enhanced/Dual power Willem Programmer
Open Source Project Willem Programmer Hardware
Wellon/WEILEI USB Programmer
TOP USB Programmer
EasyPRO/SmartPRO USB Programmer
PIC Programmer
Using the AVR JTAG ICE and AVRISP ISP programmer
--------------------
Home
Active Topics
Frequently Asked Questions
Member Information
Search Page
MCUmall EPROM BIOS Chip Burner Forum
© Copyright 2003 - 2009 Mcumall Electronics Inc.
Generated in 0.08 sec.
Snitz Forums 2000