MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 General Discuss
 S 29x94 eeprom. how to read/write ?
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

jueidi

2 Posts

Posted - 08/06/2015 :  05:52:32  Show Profile  Reply with Quote
S 29394 is an eeprom produced by Seiko.
I have a GQ4x which does not support this chip.
Is there any way to use my programmer to read it and write it
Any advice

Edited by - jueidi on 08/06/2015 06:07:01
Reply #1

ZLM

2937 Posts

Posted - 08/09/2015 :  22:46:15  Show Profile  Reply with Quote

Add following lines into devices.txt

Name="S-29194",ID="XXXX",Class="93C46B_16Bit",BufferMode="16BIT",Category="SERIAL_EPROM",MFG="Seiko";
Name="S-29294",ID="XXXX",Class="93C56B_16Bit",BufferMode="16BIT",Category="SERIAL_EPROM",MFG="Seiko";
Name="S-29394",ID="XXXX",Class="93C66B_16Bit",BufferMode="16BIT",Category="SERIAL_EPROM",MFG="Seiko";
Go to Top of Page
Reply #2

jueidi

2 Posts

Posted - 08/10/2015 :  01:57:42  Show Profile  Reply with Quote
Thanks a lot. I'll try it soon.
But this seems to be very simple.
Did you take in consideration the different : pins arrangement;frequency and read/write volt.
Go to Top of Page
Reply #3

ZLM

2937 Posts

Posted - 08/15/2015 :  07:21:37  Show Profile  Reply with Quote
That will be covered by different Classes.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000