MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X, GQ-3X, GQ-4X)
 GQ-4X 4 (New Revision) PIC 12F508 problem
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Dio

Germany
7 Posts

Posted - 12/08/2015 :  06:38:01  Show Profile  Reply with Quote
Hi, iam using the GQ-4X (new Revision) with the 3.0 USB Driver and Usbprg 7.05.

Iam programming successfull 29F032, 29F016, PIC 12F629 and M27C801 without any problems.

But with 12F508 it does not work at all. When i read it out i get only 3FFF , even at the end where the calibartion value should be.

When i program one of them with a hex file (onechip.hex for Playstation) then it seems to write fine, but when reading it out it still shows only 3FFF. So it does not seem to programm at all.

The chip is in correct position of the ZIF. If i remove it the Software freezes when i klick readout.

I tried 3 differen 12F508 (brandnew ones) from different sources.

I have no more idea why only this type does not work at all.

Does anybody have any suggestions what else i could try?

Thx a lot
Regards, Dio
Reply #1

Dio

Germany
7 Posts

Posted - 12/09/2015 :  10:52:30  Show Profile  Reply with Quote
Damn still not working. :/
Go to Top of Page
Reply #2

Dio

Germany
7 Posts

Posted - 12/15/2015 :  16:08:18  Show Profile  Reply with Quote
I exchanged the GQ-4X 4 and got another one.

But it is still not able to programm PIC 12F508. No matter what hex i program, a readout gives only 3FFFs.

Did anybody already use the GQ-4x (new revision) with a PIC 12F508 ?
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.14 sec. Snitz Forums 2000