MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Open Source Project Willem Programmer Hardware
 Programming a STM27C800 w/ Dual Powered Willem
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

chaos89-dot-com

7 Posts

Posted - 05/28/2006 :  22:30:44  Show Profile  Reply with Quote
I am having problems programming my STM27C800 eproms. I am getting the right voltage on pin 32(12.5V)
I am using the same 16-bit adaptor as for my AM27C400 eproms.
I have noticed it takes like hours to erase the STM27C800 eproms.
Does it usually take hours to fully erase these STM27C800 eproms?
Also, am I supposed to use the supplied address cable? I did try that too.

Thanks in advance!

Edited by - chaos89-dot-com on 05/28/2006 22:32:12
Reply #1

ZLM

2937 Posts

Posted - 06/04/2006 :  16:11:03  Show Profile  Reply with Quote
STM27C800 should use UV eraser to erase. Not the programmer.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.08 sec. Snitz Forums 2000