MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 probleme id et ecriture 29f400 gq-4x4
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

many

France
1 Posts

Posted - 06/05/2018 :  17:20:51  Show Profile  Reply with Quote
bonjour a tous j ai un souci d ecriture sur 29f400 et il ne me reconnais pas l id de l eprom quelqun pourrais m aidez

le savoir n est bon que si il est partagé
Reply #1

anniel

2531 Posts

Posted - 06/06/2018 :  02:52:33  Show Profile  Reply with Quote
quote:
Originally posted by many

bonjour a tous j ai un souci d ecriture sur 29f400 et il ne me reconnais pas l id de l eprom quelqun pourrais m aidez



La lecture est possible?
Go to Top of Page
Reply #2

davebb

United Kingdom
11 Posts

Posted - 06/18/2018 :  07:23:04  Show Profile  Reply with Quote
Hi I had this problem on a gq-4x, it could read but it would stop writing at 6% and would not id,
I had this problem from new, it was not the adaptor or ic pins, so I opened up the unit and tested the zif socket and found no contact on pin 11, the soldering all looked good but I de-solderd pin 11 and resolderd using some added flux and now it has made good contact and is now working reading and writing,
So check all pins with a multimeter of the zif socket to pcb of the programer
Thanks Dave
Go to Top of Page
Reply #3

anniel

2531 Posts

Posted - 06/20/2018 :  03:35:56  Show Profile  Reply with Quote
quote:
Originally posted by davebb

Hi I had this problem on a gq-4x, it could read but it would stop writing at 6% and would not id,
I had this problem from new, it was not the adaptor or ic pins, so I opened up the unit and tested the zif socket and found no contact on pin 11, the soldering all looked good but I de-solderd pin 11 and resolderd using some added flux and now it has made good contact and is now working reading and writing,
So check all pins with a multimeter of the zif socket to pcb of the programer
Thanks Dave



No need to open up the programmer to test it, you can simply use the software...
Go to Top of Page
Reply #4

davebb

United Kingdom
11 Posts

Posted - 06/20/2018 :  12:18:04  Show Profile  Reply with Quote
HOW
Thanks Dave
Go to Top of Page
Reply #5

anniel

2531 Posts

Posted - 06/20/2018 :  17:58:42  Show Profile  Reply with Quote
quote:
Originally posted by davebb

HOW
Thanks Dave



Test H/W in the menu.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.1 sec. Snitz Forums 2000