T O P I C R E V I E W |
amisouli |
Posted - 01/27/2009 : 02:24:45 Hi all,
I have the following problem: 1) I check that the device is blank and it is 2) I change the first couple of bytes on the editor 3) I click on program. - when the EPROM Memory is ticked I get 'Program Error' flashing in the status bar - when I untick it then it does 0.296s and says Successful. BUT when I verify it's clear that there has been no change in the chip.
Since I am a junior here, can you please give me the first push?
THanks a lot in advance
Regards aris
|
1 L A T E S T R E P L I E S (Newest First) |
ZLM |
Posted - 01/27/2009 : 14:09:06 The chip need to be erased before write any new data. Even one byte data changed, whole chip have to be erased under UV eraser. |
|
|