MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 JTAG/SPI in circuit programming adapter

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
tahir Posted - 07/11/2012 : 14:42:47
hi would like some instructions on how to use and connect the bove adapter please can it be done by leaving the chip in the target and also does the target needs power to it thanks
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 07/12/2012 : 14:42:37
Place the adapter on the programmer and then connect the adapter SPI/JTAG port to your target board.

See:
ADP-056 JTAG with GQ-4X for Altera EPM3128A CPLD
www.youtube.com/watch?v=RBLEZNL3L2Q

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000