MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Winbond 29C020 Fix...

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
djtech Posted - 03/19/2005 : 12:56:49
Hey guys, and know many of us are looking for a fix for the boot block on these and compatible chips...As another has suggested here, if it were possible to add the instruction to the Willem software to disable the boot block, it would be a BIG help to program these chips...As for now, most of us have to use the Hotswap trick, and that's only if we have a suitable motherboard lying around to do it...

I have been given some info on another possible fix, maybe someone might have some insight how we could set this up using the Willem...Basically I was told that if 12V is put on the VPP/RESET pin then the chip would ignore the boot block and allow proper programming...There have been success stories doing this thus far apparently...How would we manipulate this on the Willem board easily?

Finally here is some info on getting into the lockout mode...

[05555],0AA
[02AAA],055
[05555],080
[05555],0AA
[02AAA],055
[05555],040
[02AAA],0AA

Then after:

[00000],0 - enable bottom block lockout
[3FFFF],0FF - enable top block lockout

And the undocumented one:
[02AAA],0AA - disable both top&bottom block lockout

Maybe the software guys can help implement this?

Here is the Winbond datasheet on it too..
http://www.winbond-usa.com/products/winbond_products/pdfs/Memory/w29c020c.pdf?PHPSESSID=f7c67c7a34a0644dbde89332b4fcf6c1

Thanks all, hopefully this can get fixed soon :)
1   L A T E S T    R E P L I E S    (Newest First)
mcumall Posted - 04/01/2005 : 17:15:07
Thank you for your good information.
I'm sure someone will modify the software.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000