MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using the AVR JTAG ICE and AVRISP ISP programmer
 Atmega 328P-PU How can clone this

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
danmarq Posted - 12/17/2017 : 15:27:20
Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so...

How can i do this is possible ?

the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?

Someone can do this before ?

Regards :)
3   L A T E S T    R E P L I E S    (Newest First)
anniel Posted - 12/18/2017 : 04:21:36
quote:
Originally posted by danmarq

Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :)



+1 Good info for others in same situation.
anniel Posted - 12/18/2017 : 04:20:11
quote:
Originally posted by danmarq

Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so...

How can i do this is possible ?

the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?

Someone can do this before ?

Regards :)



SCK is pin 19.

danmarq Posted - 12/17/2017 : 22:33:33
Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :)

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000