MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 Programming 27C322 and 27C160

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
ben1059 Posted - 08/13/2006 : 11:33:28
I just bought the dual power willem eprom programmer with the 16 bit adaptor. I didnt get the diy cable set but instead I got three jumper wires. I can't figure out how to program 27C322 and 27C160 eproms. There isn't anything in the instructions on how to do it nor is there anything in the software that helps.
3   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 02/25/2008 : 08:49:00
If programming fail on random location, the your PCB3B does not work well on M27C800, M27C160 and M27C322. This is common issue on all PCB3B.
Necrosaro420 Posted - 02/23/2008 : 20:23:01
Sorry to dig up an old topic, but I am having the same issue. I have a willem pcb3, and I bought an sivava adapter of ebay ( http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&rd=1&item=370014757919&ssPageName=STRK:MEWN:IT&ih=024 )

I set the jumpers according to willems software, and I get errors as soon as I started programming every time =(
ZLM Posted - 08/22/2006 : 11:39:50
The three jumper wires are for the address line A19,A20,A21. Just connect those address line from adapter's address pin header to main programmer's address pin header.

See: http://www.mcumall.com/forum/topic.asp?TOPIC_ID=106 for the main pin header on the programmer board.

The DIP switch and the jumper setting need to confirmed with software indication when you selected the chip type from the software.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000