MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 newbie question

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
the_graze Posted - 06/14/2014 : 18:07:10
i have the GQ_4X great programmer i have used it to read write eeproms but my question is i want to jtag a 9S12H microcontroller ic on board i do have a six pin flat pad on the board i can solder or connect to for the purpose of communication is the or will the GQ-4X capable of this and what adapter would i need to carry this task through? the six pin pad has, positive, negative, bdm, reset only four of the pins are used from the research i have done so far. this is of course automotive related question thank you for any help greatly accepted. I have uploaded the pin pads as seen here at the tip of the screwdriver.

Image Insert:

47.27 KB
1   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 06/15/2014 : 23:29:06
Sorry. The GQ-4X JTAG does not support this chip.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.04 sec. Snitz Forums 2000