MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 need immediatehelp

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
Check here to include your profile signature.
    

T O P I C    R E V I E W
SpartanXx666xX Posted - 07/16/2010 : 20:49:56
hey guys,

i just received my prg-017 in the mail and i tried to program my 12f683 chips and it wont write.

I open the program and select the 12f683 on the right bottom corner and place the chip accordingly. and when i load the hex file and click on program---i get the messaeg "the programmer does not recognize (12f683) processor. Continue anyway? I click yes and then i get the error "Received data error Apply reset"

i just went back and checkd the hex. the error starts from the EEPROM Data. because the error says good at 0x2b06 and bad at 0x000---where the EEPROM Data starts..

plz help

please help

thank you
3   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 07/17/2010 : 22:28:47
Well, if the chip is very thing good, then the software should be able to talk to it with out any error message.
SpartanXx666xX Posted - 07/17/2010 : 09:10:50
is there a way to make sure the 18pin is connected properly through software maybe?

and i tried the steps you mentioned and I am trying it on my laptop Windows 7 right now and still same thing
ZLM Posted - 07/17/2010 : 08:24:46
If the programmer does not detect the chip, then there are must be someting wrong.

check if the on board 18 pin DIP controller not loose from socket.
Change a USB cable.
Try it on another computer.

If the problem same, then contact the support@mcumall.com for warranty.

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000