MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 EasyPRO/SmartPRO USB Programmer
 Easyrpo 90B
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

idylewild1

USA
1 Posts

Posted - 02/05/2008 :  13:15:11  Show Profile  Reply with Quote
I recently purchased an Easypro 90B and can't seem to get it working. I have followed the help file to no avail. I have read a file from a chip and sved this data. What I can't seem to get to working is to copy this progam back to another erased chip. Any help would be greatly appreaciated.
Reply #1

ZLM

2937 Posts

Posted - 02/06/2008 :  17:02:22  Show Profile  Reply with Quote
steps to copy an EPROM chip:

1. Connect the programmer, run software.
2. Select the chip type.
3. insert the original chip, make sure the orientation is correct.
4. read the chip, save the data in buffer if needed.
5. remove the original chip and then put the new blank chip in same position in the ZIF.
6. blank check the chip see if the chip is blank indeed.
7. write the chip.

===================================

steps to write a new EPROM chip from a saved data file:

1. Connect the programmer, run software.
2. Select the chip type.
3. open the data file you would like to write.
4. put the new blank chip in same position in the ZIF.
5. blank check the chip see if the chip is blank indeed.
6. write the chip.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.11 sec. Snitz Forums 2000