MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 Zif socket adapter
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Aurbo

1 Posts

Posted - 04/10/2008 :  15:05:08  Show Profile  Reply with Quote
I purchased one of your Enhanced JDM units similar to this:

http://cgi.ebay.com/Enhanced-JDM-PIC-programmer-4-Microchip-12F629-New-V2_W0QQitemZ310040238073QQihZ021QQcategoryZ1504QQrdZ1QQssPageNameZWD4VQQcmdZViewItem?_trksid=p1638.m124

This unit has the 3 sockets in two rows with silk screened indicators for proper chip placement.

What ZIF socket should I buy? and will the single ZIF socket allow me to program all the various chips supported? or will I have to remove it and insert the chip in the old sockets again depending on pin count?
Reply #1

ZLM

2937 Posts

Posted - 04/10/2008 :  18:44:34  Show Profile  Reply with Quote
The V2 version JDM is not designed to solder a ZIF socket. If you replace the DIP by a 40 pin ZIF, then only 40 pin chips are able to be programmed.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000