MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Using The Enhanced/Dual power Willem Programmer
 *Help* error message when i program/verify		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ryry310

USA
4 Posts
Posted - 07/02/2009 :  13:39:30  Show Profile  Reply with Quote
I just bought my dual power Willem programmer and using it for the first time. I'm using SST49FL020 LPC chip and it erases/reads and shows me the electronic ID as 0x25 0x42 [....], however when I try to verify or program i get "ERROR at 0x000001 Chip x 42 buffer= 0x8C"

The hardware is present and I am powering via 12V DC, and my DIP switches are configured like the image. Can anyone please help me?

The PCB version is 5.0C, but I am using 97.ja and I have the jumper set to PCB3.0

I have a feeling the ID is incorrect and my chip is damaged..can anyone confirm?
Edited by - ryry310 on 07/02/2009 14:00:24
Reply #1

ZLM

2937 Posts
Posted - 07/03/2009 :  16:01:08  Show Profile  Reply with Quote
The ID is incorrect.

Try to use software 0.98D6.
Go to Top of Page
Reply #2

ryry310

USA
4 Posts
Posted - 07/09/2009 :  09:32:17  Show Profile  Reply with Quote
Thanks, but can you tell me where I can download the software 0.98D6?

It's not the one that came with my cd.
Go to Top of Page
Reply #3

ryry310

USA
4 Posts
Posted - 07/09/2009 :  10:25:03  Show Profile  Reply with Quote
I've tried .97ja and .98D5 still ID is wrong.. (I get [.....] Is there something wrong with my bios chip?
Go to Top of Page
Reply #4

simeon

United Kingdom
79 Posts
Posted - 07/15/2009 :  02:09:04  Show Profile  Reply with Quote
perhaps you need other than 5 or 5.6v vcc to flash it
check the datasheet i cant find it
often these eeproms need a higher vcc or they wont program

just a thought...??? not sure myself i never did this or needed to

for eproms you need 6.25v {5v5.6v jumper removed}
with your 5.0c
i have the same ?? revision

you also need to use pcb5.0c jumpers and use v5.0 98D8 or D10
software
its more reliable
machine toshiba equium laptop usb only type
p5b asus main machine
thinking of adding dual lpt pci card
both used for top and lpt via usb where i can

old p2 programming grumbling tank with xp sp3 for true serial and lpt

all machines bios set to enable bios plug and play aware o/s and lpt spollers services and drivers removed
legacy detection enabled
Edited by - simeon on 07/15/2009 02:14:18
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.14 sec. Snitz Forums 2000