MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 USB-PIC Board Failure
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  


7 Posts

Posted - 11/05/2009 :  16:27:12  Show Profile  Reply with Quote
I was programming a 18f4525 chip and was getting a notice of OK at 0xefea Bad at 0xffff failed at 0x0000 for a couple of times.

Now I have USB-PIC board connected and it's connected to COM4, but every time I try to read, write or anyhing else it comes up with
Checking for 18f4525 then
then a popup with:
The board is not responding
About to apply reset...
When I press OK it says resetting and goes back to
USB-PIC board connected

Thanks in advance for any help
Reply #1


7 Posts

Posted - 11/05/2009 :  16:43:00  Show Profile  Reply with Quote
Just figured mine out.

There's a file in the USB IC Programmer directory
named pro.dat

I changed the name to pro1.dat so i could fix later if i had to.
It is the preference file for the programmer andmade me reset the COMM and the programmer name as in the beginning.
Now everything works again.

Thanks anyway

Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000