MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 TOP USB Programmer
 Top 2004 trouble pin contact 21
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

KilrPilr

Canada
8 Posts

Posted - 02/19/2006 :  11:47:53  Show Profile  Reply with Quote

Hello
I had a top 2004 eprommer. It worked fine programming eproms and such for a few months but now its giving this message: "trouble pin contact: 21" and the eprommer wont work right even with the error messages turned off. The wipers on the zif have been checked and they are all closing tightly against the legs of the eproms. What could be causing this. I am using the up to date software and a decent usb cable.


Leo
Reply #1

ZLM

2926 Posts

Posted - 02/20/2006 :  16:07:12  Show Profile  Reply with Quote
The TOP2004's ZIF socket should be soldered on the PCB, so it should not have contact issue. Make sure the ZIF's pin 21 is clean. If the error message continue on every different chips, then your programmer may need a check service or repair.

Edited by - ZLM on 02/20/2006 16:08:33
Go to Top of Page
Reply #2

KilrPilr

Canada
8 Posts

Posted - 02/21/2006 :  09:58:55  Show Profile  Reply with Quote
Yeah well there is nothing I can do to get past it. If I turn off the error message it reads eproms but the info is corrupted. Where can i send it to get it fixed and any idea how much it would cost or if its even worth it? Thanks
Go to Top of Page
Reply #3

ZLM

2926 Posts

Posted - 02/21/2006 :  12:01:50  Show Profile  Reply with Quote
Write to support@mcumall.com for the detailes.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.23 sec. Snitz Forums 2000