MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Problem With JDM prog. and 16F688
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

ailgup

2 Posts

Posted - 05/12/2010 :  15:29:29  Show Profile  Reply with Quote
Okay i am new to this and i plugged the programmer into the computer and both LED's went on then when i placed in the pic with 3 rows left to the back and 10 to the front the green led goes off and only the red one is on. Then when i go to program it using the .hex file i get this error :ERROR->writing address 0x000000
Written:0x0000 Read:0x3FFF
when ti tries to program the red led blinks a little. I think that i have the settings right in Winpic800 i selected the right hardware and it says that it sees the programmer so i don't know what i'm doing wrong?
chris
Reply #1

ailgup

2 Posts

Posted - 05/12/2010 :  17:12:13  Show Profile  Reply with Quote
i can read the chip but when i try to erase it ,gives me an error, there is data on the chip so it needs to be removed first.
Go to Top of Page
Reply #2

ZLM

2937 Posts

Posted - 05/15/2010 :  00:13:00  Show Profile  Reply with Quote
How do you know the reading is woking good?
Does the software can detect the chip?
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.06 sec. Snitz Forums 2000