MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 PIC Programmer
 fuse errors
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  


3 Posts

Posted - 05/13/2011 :  07:49:11  Show Profile  Reply with Quote
Is anyone out there any good at troubleshooting a hex code that gives fuse errors. I have a lighting project I did with a pic18f20k25. The project came with a hex file and I got the website to reluctantly give me a second hex file. both give a fuse error. Different lines, but the same code sequence in those lines. I have a feeling it is a fuse setting but I can't get any support from the website that put the code out.
Here is the project:

The hex code is available at the website. I think it's the third line from the bottom:
gives a fuse error.
Any help would be greatly appreciated since I'm already $50 into this project.
Reply #1


6 Posts

Posted - 10/24/2011 :  06:20:46  Show Profile  Reply with Quote

Not sure if this is the same problem, but I had a similar issue with the PRG-017 and a PIC18.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.12 sec. Snitz Forums 2000