MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Automobile engine ECU, Immo, Air bag chip tunning
 Address lines scrambled
 Forum Locked
 Printer Friendly
Author Previous Topic Topic Next Topic  

sabercatpuck

USA
5 Posts

Posted - 12/18/2009 :  07:22:32  Show Profile
I am working on dissasembling the ECM for my car (well as junk yard version similar to my car) and found that several of the address lines were swapped (pairs A1-A13, A2-A12, A3-A11, A10-A14). Using a willem 5.0 is there any way to correct this while uploading the program in software or am I looking at needing to build a small conversion board to do it at a hardware level?
Reply #1

sabercatpuck

USA
5 Posts

Posted - 12/18/2009 :  14:55:30  Show Profile
Well after several hours of messing around with some floppy cables and plugs I unsoldered from a motherboard I was able to set up a bear skins and bailing wire adaptor and was able to pull the data from the chip. Although if there are any people who know how to do this easier I still would like to know.
Go to Top of Page
Reply #2

ZLM

2945 Posts

Posted - 12/19/2009 :  22:03:32  Show Profile
The simplest way is un-soldering the chip and place the chip in an adapter. and then read it from the programmer.
Go to Top of Page
Reply #3

sabercatpuck

USA
5 Posts

Posted - 12/24/2009 :  10:12:57  Show Profile
I had already unsoldered the chip (and installed a socket). While making a copy of the data is not a problem with the scrambled address lines, trying to dissaemble the code is. It is like putting a piece of mail in a downtown holdout and expecting it to end up in the suburbs, makes it very difficult to get anything out of the disassembly. The adaptor was actually a bunch (32 to be specific) of wires (thin stuff from a piece of network cable) that I soldered on to the ends of a couple ribbon cables and then inserted into a socket with the chip, with the address lines going to where they needed to to get unscrambled data from the chip.
On a side note, when I tried to change a few things and flash it I apparently had a slightly different version of the chip (both 28f010's) that would not flash it, but that problem I have straightened out. I still may need to get a logic analyzer to watch the data flow though. Anyone know a way to tag into the PCI bus? You have 64 high speed data lines available for all your decoding needs if you can get at em. I have seen some on the parallel port, butt they only give you 8 bits which only lets you see the data.
Go to Top of Page
  Previous Topic Topic Next Topic  
 Forum Locked
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.07 sec. Snitz Forums 2000