MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 TOP USB Programmer
 I can't program 16f84a
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

hsny

3 Posts

Posted - 07/20/2007 :  00:36:58  Show Profile  Reply with Quote
I don't know if my pic 16f84a is programmed or not. I load the hex file with the "load" menu from software.I choose my pic form "type" menu. I press detect but nothing happened.So I press "yes" but I dont understand the configs so dont thick none of them.I press "run", it says "achieved" .I press read and I see the same hex file but when I press "readdata" I get the 00 00 00 00... file.
And my circuit doesn't work with my pic.
Do you think I programmed my pic? How can I know? what's the problem?

Edited by - hsny on 07/21/2007 06:12:52
Reply #1

ZLM

2926 Posts

Posted - 07/20/2007 :  20:35:14  Show Profile  Reply with Quote
Check if you turned on the Code Protection bit (CP).
Go to Top of Page
Reply #2

hsny

3 Posts

Posted - 07/25/2007 :  02:56:41  Show Profile  Reply with Quote
I don't know how config the fuses?
There are lots of CP...
Which CP I thick ?Normally I dont thick none of them.
I still cant program the pic.
Now it says "verify error" .
and "code not blank"

Edited by - hsny on 07/25/2007 05:12:06
Go to Top of Page
Reply #3

dangerous

United Kingdom
4 Posts

Posted - 08/02/2007 :  12:51:40  Show Profile  Reply with Quote
How are you writing the code? MPASM lets you set and embed the config codes in the Hex file. Then you load the HEX file to TOPWIN.

You could try MikroBasic from Mikroelektronika. Find it in Google.

It is free for code upto 2K (more than a PIC84 full), has a very good forum and lots of example code. Again it produces HEX code.

Always read the datasheet from Microchip, and look at their Appnotes.
They will show you how to set CP bits.

You should be able to erase the PIC using the erase button. If you do, you should then read FF in every slot. Prove that the PIC works by filling the buffer with 00 and program chip. Read should now show 00. Erase and you should read FF again. This should work whatever state the CP bits are in.
Go to Top of Page
Reply #4

hsny

3 Posts

Posted - 08/07/2007 :  00:18:11  Show Profile  Reply with Quote
I use a jdm programmer with winpic and program my pic.I still cant program with topwin.I'll try again later.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.23 sec. Snitz Forums 2000