| Author |
 Topic  |
|
|
danmarq
11 Posts |
 Posted - 12/17/2017 : 15:27:20
|
Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so... 
How can i do this is possible ?
the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?
Someone can do this before ?
Regards :) |
|
| Reply #1
danmarq
11 Posts |
Posted - 12/17/2017 : 22:33:33
|
| Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :) |
 |
|
| Reply #2
anniel
2589 Posts |
Posted - 12/18/2017 : 04:20:11
|
quote:
Originally posted by danmarq
Hello guys , i need make a buckup of an Atmega328P-PU on another atmega328xxx , i have an Willem QG4x4 using 7.11 software. this say AVRISP conection needed, so...
How can i do this is possible ?
the usbprg software show an pic with RST, MISO, SCK, GND, MOSI. I need conect pins of Atmega to willem pins? only that ? and.. on atmega where is the SCK?
Someone can do this before ?
Regards :)
SCK is pin 19.
 |
|
|
| Reply #3
anniel
2589 Posts |
Posted - 12/18/2017 : 04:21:36
|
quote:
Originally posted by danmarq
Solved ,i used arduino uno for supply voltage and ICSP out to willem GND, SCK, MISO, MOSI and RST. :)
+1 Good info for others in same situation. |
|
|
| |
Topic |
|
|
|
Atmega 328P-PU How can clone this
Forum Locked
