I have the following problem: 1) I check that the device is blank and it is 2) I change the first couple of bytes on the editor 3) I click on program. - when the EPROM Memory is ticked I get 'Program Error' flashing in the status bar - when I untick it then it does 0.296s and says Successful. BUT when I verify it's clear that there has been no change in the chip.
Since I am a junior here, can you please give me the first push?
EasyPRO90B can't program HN27128G
Posted - 01/27/2009 : 02:24:45
