MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 TOP USB Programmer
 help setting up configuration for PIC
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

TheRain

5 Posts

Posted - 03/15/2006 :  19:02:31  Show Profile  Reply with Quote
This is my first attempt at a PIC project. I'm using a TOP2004 with a PIC16F877A chip. My problem is that I cannot figure out what the configuration bits should be set to in the top programmer software. Mostly it is the FOSC0 and FOSC1 that I am not sure what to do with. I want to use a 4Mhz crystal with my PIC... besides that I am just trying to blink a single LED from PORTB bit 0. Can anyone help??
Reply #1

ZLM

2937 Posts

Posted - 03/15/2006 :  21:35:51  Show Profile  Reply with Quote
see:
http://ww1.microchip.com/downloads/en/devicedoc/39582b.pdf
Go to Top of Page
Reply #2

TheRain

5 Posts

Posted - 03/15/2006 :  21:49:02  Show Profile  Reply with Quote
thanks, but that doesn't really help... I need to set it up for XT clock I think, but I see no way of doing that.
Go to Top of Page
Reply #3

TheRain

5 Posts

Posted - 03/15/2006 :  23:13:01  Show Profile  Reply with Quote
ok, nevermind... i didn't see how this corresponded but now I see the configuration bits in there... thanks!
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.19 sec. Snitz Forums 2000