MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 True USB Willem Programmer (GQ-2X,3X,4X & GQ-4x4)
 AMIC A29040C
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Gagostini

Spain
3 Posts

Posted - 03/05/2017 :  03:09:15  Show Profile  Reply with Quote
Hi all. Iīm trying to program an AMIC A29040C flash but this one is not on the device list. How can I program it? I tried with A29040B but donīt work. My progemmer is an USB GQ-3X.

Edited by - Gagostini on 03/05/2017 03:11:03
Reply #1

anniel

2531 Posts

Posted - 03/05/2017 :  05:10:00  Show Profile  Reply with Quote
What is the error message when using A29040B?
Go to Top of Page
Reply #2

Gagostini

Spain
3 Posts

Posted - 03/05/2017 :  08:21:26  Show Profile  Reply with Quote
When the programmer checks ID says: "ID check failed.("FFFF") Please check device type, chip orientation and pin contact. Some OEM chips may have compatible chip ID. Continue?"
After pressing "yes" button it says: "Write failed, Address=0x000000, Buffer=0x16 Device=0FF"

I have lots of AMIC A29040B and never failed, but the AMIC A29040C always fails.
Go to Top of Page
Reply #3

anniel

2531 Posts

Posted - 03/05/2017 :  11:36:39  Show Profile  Reply with Quote
A29040B and A29040C have the same ID. Probably a bad chip if the pins are clean.
Go to Top of Page
Reply #4

Gagostini

Spain
3 Posts

Posted - 03/12/2017 :  09:19:38  Show Profile  Reply with Quote
I have over 20 chips and all have the same problem. I have achieved to program two of them, but I needed at least five tries.
Go to Top of Page
Reply #5

anniel

2531 Posts

Posted - 03/12/2017 :  13:53:39  Show Profile  Reply with Quote
Did you try a lower speed?
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.09 sec. Snitz Forums 2000