MCUmall EPROM BIOS Chip Burner Forum
MCUmall EPROM BIOS Chip Burner Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 MCUmall Forums
 Novice Place
 Enhanced dual power with mikrobasic and PIC16F88

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
don954 Posted - 10/18/2007 : 16:21:39
So i have the enhanced dual power programmer, the jumpers are all set in the original positions PCB3.5 and i'm using the correct software for that setting. I have set the parallel port to EPP in the bios. I have chosen the correct oscillator settings and turned code protect off etc. I have a program that was created in mikrobasic, and i know it works because i have tested it on PIC16F88's at the university using their programmers. When i try to program it on the 88's i have at home, it does not verify. I did notice that for most of the other PIC chips the picture tells you where to put your MC but when i select the 88 from the device menu it doesn't show any MC in the little picture.. possible problem? I have been putting in the location for a PIC16F676. Does anyone have any insight as to why it would not be verifying? I am very frustrated and would really appreciate any help.

Thank you.
2   L A T E S T    R E P L I E S    (Newest First)
ZLM Posted - 10/21/2007 : 18:36:30
Did you try using the software IC-prog1.05D?
don954 Posted - 10/21/2007 : 12:13:32
Anybody have input? do i need to provide more info or be more clear about the problem or perhaps my question?

MCUmall EPROM BIOS Chip Burner Forum © Copyright 2003 - 2009 Mcumall Electronics Inc. Go To Top Of Page
Generated in 0.05 sec. Snitz Forums 2000